Wood Type Mini Tutorial in @procreate
(Thread)

1. Draw out each letter, creating a new layer for each character. Also, make a new layer for each overlapping crossbar. Like letters E, F, H, T.
Color #745742 Brush: Inking - Studio Pen

2. Create a new layer above your letter, click on the thumbnail & select clipping mask. Draw a half-circle at one end of the stem or crossbar ( #f3c18a). Then draw some rings inside that ( #ddb17b)

3. Create a new clipping mask layer. Draw cracks at one end of the wood and bark lines along the rest of it. ( #3a220f)

4. Draw highlights on the edge, cracks and bark. Add it to the right if the line is vertical or add it to the bottom if horizontal. ( #bf8f72)

5. Create a new clipping mask layer. Draw highlights on the sides of the wood. On the left of vertical stems & at the top of horizontal stems. ( #88694e)

6. Draw shadows on the wood. On the right of vertical stems & at the bottom of horizontal stems. (#594539)

7. Create a new clipping mask layer for the underlying stems. draw shadows to the right and a little to the left. Change the opacity (N symbol) to multiply and reduce to 40-50%. (#594539)

8. Create a new layer (not a clipping mask) and draw some leaves. Use green ( #5b6800) and then add a highlight ( #9eaa24) to the top and middle

Info:
iPad Pro 12.9 inch
Apple Pencil
LetterBuilder brushes used: http://www.ianbarnard.co